Inside the <tablescope> element the scope parameters for the generation of decompression tables (see also <calculatetable>) are put into brackets.
If <table> is given, <tablescope> must occur, too.
<table>
<altitude>, <bottomtimemaximum>, <bottomtimeminimum>, <bottomtimestepbegin>, <bottomtimestepend>, <divedepthbegin>, <divedepthend>, <divedepthstep>
<table>
(see also <table>)
<table id="decotable_nitrox4060_0m"> <!-- cross reference to a previous dive ("dive500"); on basis of the tissue --> <!-- saturation due to this previous dive now the table is to be generated --> <link ref="dive500"/> <!-- cross reference to the breathing gas to be used --> <link ref="nitrox4060"/> <surfaceintervalbeforedive> <!-- a pause of 3 h between dives --> <passedtime>10800.0</passedtime> </surfaceintervalbeforedive> <!-- salt water --> <density>1030.0</density> <!-- in the following statements for output into a file --> <output> <!-- output language is English --> <lingo>en</lingo> <!-- PDF format (-> file extension ".pdf") --> <fileformat>pdf</fileformat> <!-- name of output file (extension ".pdf" must not be given!) --> <filename>table_nitrox4060_0m</filename> <!-- headline for table --> <headline>Table for Sealevel - Nitrox 40/60</headline> <!-- some illustrative text or other remarks --> <remark> This is a special table for our proposed descent to the shallow south of Gabiniere. </remark> </output> <applicationdata> <!-- here software specific data --> </applicationdata> <decomodel>zh-l16</decomodel> <!-- take into account deep stops of 1 minute length --> <deepstoptime>60.0</deepstoptime> <!-- maximum ascending rate 10 m/min --> <maximumascendingrate>0.1666666667</maximumascendingrate> <tablescope> <!-- height above sea level for which the table is to be calculated --> <altitude>0.0</altitude> <!-- beginning with a depth of 3 m, maximum depth 30 m, increment 3 m --> <divedepthbegin>3.0</divedepthbegin> <divedepthend>30.0</divedepthend> <divedepthstep>3.0</divedepthstep> <!-- maximum bottom time 30 minutes, to be taken into account for the table --> <bottomtimemaximum>1800.0</bottomtimemaximum> <!-- minimum bottom time 5 minutes, to be taken into account for the table --> <bottomtimeminimum>3.0.1</bottomtimeminimum> <!-- at beginning (at minimum dive depth) increment of 10 minutes --> <bottomtimestepbegin>600.0</bottomtimestepbegin> <!-- at the end (at maximum dive depth) increment of 1 minute --> <!-- Schrittweite auf der maximalen Tauchtiefe 1 Minute --> <bottomtimestepend>60.0</bottomtimestepend> </tablescope> </table>